Model No. WF32DTLAJDNN0
►Size; 3.2"
►Resolution : 240 x 320 dots
►View Direction: 6H
►Interface: 8080/MCU/SPI
►Driver IC: ILI9341
►Control-Board : No
►Brightness(cd/m²): 500
►Frame Through Hole: No
►Touch Screen : No
The WF32DTLAJDNN0 is a portrait-oriented TFT LCD module with a diagonal size of 3.2 inches. It boasts a resolution of 240x320 dots and a brightness of 500 cd/m2 (typical value). Equipped with a built-in ILI9341 driver IC, it supports 80 MCU 8-bit/9-bit/16-bit/18-bit/SPI (3-Wire/4-Wire) interfaces. The module measures 55.04 (W) x 77.6 (H) mm, with an active area size of 48.6 x 64.8 mm.
The WF32DTLAJDNN0 supports a 6 o'clock viewing direction and features an anti-glare glass surface. It functions efficiently within a temperature range of -20℃ to +70℃, while its storage capabilities extend from -30℃ to +80℃. The logic supply voltage for the module ranges from 2.5V to 3.3V.
A 3.2-inch (AA 48.6×64.8 mm)TFT display is a small display module that is suitable for a variety of applications, including:These applications represent just a few examples of the diverse potential uses for a 3.2-inch (AA 48.6×64.8 mm) TFT display. The specific utilization will depend on the product's requirements and the desired features and performance of the display.
| Item | Dimension | Unit |
|---|---|---|
| Size | 3.2 | inch |
| Dot Matrix | 240x RGB x 320(TFT) | dots |
| Module dimension | 55.04 (W) x 77.6 (H) x 2.55(D) | mm |
| Active area | 48.6 x 64.8 | mm |
| Pixel pitch | 0.2025 x 0.2025 | mm |
| LCD type | TFT, Normally White, Transmissive | |
| View Direction | 6 o'clock | |
| Gray Scale Inversion Direction | 12 o'clock | |
| Aspect Ratio | Portrait | |
| Driver IC | ILI9341 or Equivalent | |
| Interface | 80 MCU 8bit /9bit/16bit/18bit/SPI (3-Wire/4-Wire) | |
| Backlight Type | LED, Normally White | |
| Touch Panel | Without Touch Panel | |
| Surface | Anti-Glare | |
| Item | Symbol | Min | Typ | Max | Unit |
|---|---|---|---|---|---|
| Operating Temperature | TOP | -20 | － | +70 | ℃ |
| Storage Temperature | TST | -30 | － | +80 | ℃ |
| Item | Symbol | Condition | Min | Type | Max | Unit |
|---|---|---|---|---|---|---|
| Power supply voltage | VCI | 2.5 | 2.8 | 3.3 | V | |
| Power supply voltage | IOVCC | 1.65 | 2.8 | 3.3 | V | |
| Input high voltage | Vih | 0.7IOVCC | - | IOVCC | V | |
| Input low voltage | Vil | GND | - | 0.3IOVCC | V | |
| Output high voltage | Voh | IOL=-1.0mA | 0.8 IOVCC | - | IOVCC | V |
| Output low voltage | Vol | IOL =1.0mA | GND | - | 0.2 IOVCC | V |
| Current consumption | IVCI | - | - | 5.5 | 8.25 | mA |
| NO | Symbol | Function | I/O | ||||||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 1 | NC | No connection | － | ||||||||||||||||||||||||||||||||||||||||||||
| 2 | NC | No connection | － | ||||||||||||||||||||||||||||||||||||||||||||
| 3 | NC | No connection | － | ||||||||||||||||||||||||||||||||||||||||||||
| 4 | NC | No connection | － | ||||||||||||||||||||||||||||||||||||||||||||
| 5 | VCI | Power supply(TYP: 2.8V). | P | ||||||||||||||||||||||||||||||||||||||||||||
| 6 | IOVCC | Power supply(TYP:1.8V/2.8V). | P | ||||||||||||||||||||||||||||||||||||||||||||
| 7-24 | DB17-DB0 | Data Bus | I/O | ||||||||||||||||||||||||||||||||||||||||||||
| 25 | SDA | Serial data input/output | I/O | ||||||||||||||||||||||||||||||||||||||||||||
| 26 | DOTCLK | Data enable signal in RGB interface. | I | ||||||||||||||||||||||||||||||||||||||||||||
| 27 | DE | A data ENABLE signal in RGB I/F mode | I | ||||||||||||||||||||||||||||||||||||||||||||
| 28 | HSYNC | Horizontal synchronizing signal in RGB interface | I | ||||||||||||||||||||||||||||||||||||||||||||
| 29 | VSYNC | Vertical synchronizing signal in RGB interface | I | ||||||||||||||||||||||||||||||||||||||||||||
| 30 | NRD | Read enable pin I80 parallel bus system interface | I | ||||||||||||||||||||||||||||||||||||||||||||
| 31 | NWR_DNC | NWR Write enable pin I80 parallel bus system interface DNC Command/parameter or display data selection pin in serial bus system interface |
I | ||||||||||||||||||||||||||||||||||||||||||||
| 32 | DNC_SCL | DNC Command/parameter or display data selection pin in parallel interface SCL Serial data clock in serial bus system Interface |
I | ||||||||||||||||||||||||||||||||||||||||||||
| 33 | NCS | Chip select signal | I | ||||||||||||||||||||||||||||||||||||||||||||
| 34 | NRESET | System Reset | I | ||||||||||||||||||||||||||||||||||||||||||||
| 35 | IM0 | System interface select:
|
I | ||||||||||||||||||||||||||||||||||||||||||||
| 36 | IM1 | ||||||||||||||||||||||||||||||||||||||||||||||
| 37 | IM2 | ||||||||||||||||||||||||||||||||||||||||||||||
| 38 | GND | Ground | P | ||||||||||||||||||||||||||||||||||||||||||||
| 39 | VLED+ | Anode of LED backlight. | P | ||||||||||||||||||||||||||||||||||||||||||||
| 40 | VLED- | Cathode of LED backlight. | P | ||||||||||||||||||||||||||||||||||||||||||||
By clicking "Allow All Cookies", you agree to the storing of cookies on your device to enhance site navigation, analyse site usage, and assist in our marketing and performance efforts. You can find further information this subject in our policy.
