Display OLED I2C Gráfico 0,71 polegadas 48x64
Model No. WEO004864A
►Tipo: Gráfico
►Estrutura: COG
►Tamanho: 0,71 polegadas
►Matriz de pontos 48x64
►IC：SSD1306
►Alimentação +3V
►1/64 duty
►Interface: I2C
►Display Color: Branco / Amarelo
►Other FPC options available in below table
Descrição
Este é um display COG OLED fabricado com 48x64 pontos e tamanho diagonal de 0,71 polegadas. Este módulo tem dimensão de módulo de 13,90 x 22,0 mm e área ativa de 10,54 x 14,70 mm.
WEO004864A display OLED Gráfico 0,71" integrado com IC controlador SSD1306; suporta interface I2C, fonte de alimentação 3V, 1/64 para o acionamento, relação de contraste de 10,000:1. Este módulo pode operar a temperaturas de -40℃ a +80℃; suas temperaturas de armazenamento variam de -40℃ a +85℃.
FPC Options
DRAWING
Data source ref: WEO004864AWPP3N00000
SPECIFICATIONS
Função do pino de interface
| No. | Símbolo | Função |
|---|---|---|
| 1 | C2N | Positive Terminal of the Flying Inverting Capacitorr Negative Terminal of the Flying Boost Capacitor The charge-pump capacitors are required between the terminals. They must be floated when the converter is not used. |
| 2 | C2P | |
| 3 | C1P | |
| 4 | C1N | |
| 5 | VBAT | Power Supply for DC/DC Converter Circuit This is the power supply pin for the internal buffer of the DC/DC voltage converter. It must be connected to external source when the converter is used. It should be connected to VDD when the converter is not used. |
| 6 | NC | No connection. |
| 7 | VSS | Ground of Logic Circuit This is a ground pin. It acts as a reference for the logic pins. It must be connected to external ground. |
| 8 | VDD | Power Supply for Logic This is a voltage supply pin. It must be connected to external source. |
| 9 | RES# | Power Reset for Controller and Driver This pin is reset signal input. When the pin is low, initialization of the chip is executed. |
| 10 | SCL | Host Data Input/Output Bus When serial mode is selected, D1 will be the serial data input SDIN and D0 will be the serial clock input SCLK. When I2C mode is selected, D2 & D1 should be tired together and serve as SDAout & SDAin in application and D0 is the serial clock input SCL. |
| 11 | SDA | |
| 12 | IREF | This is segment output current reference pin. When external IREF is used, a resistor should be connected between this pin and Vss to maintain the IREF current at a maximum of 30uA. When internal IREF is used, this pin should be kept NC |
| 13 | VCOMH | Voltage Output High Level for COM Signal This pin is the input pin for the voltage output high level for COM signals. A capacitor should be connected between this pin and VSS. |
| 14 | VCC | Power Supply for OEL Panel This is the most positive voltage supply pin of the chip. A stabilization capacitor should be connected between this pin and VSS when the converter is used. It must be connected to external source when the converter is not used. |
Dados Mecânicos
| Item | Dimensão | Unidade |
|---|---|---|
| Matriz de pontos | 48 × 64 ponto | － |
| Dimensão do módulo | 13.90 × 22.0 × 1.26 | mm |
| Área ativa | 10.54 × 14.70 | mm |
| Tamanho do ponto | 0.198 × 0.208 | mm |
| Distância entre pontos | 0.220 × 0.230 | mm |
| Distância entre pontos | Passive Matrix | |
| Panel Type | Monochrome | |
| Drive Duty | 1/64 Duty | |
| IC | SSD1306 | |
| Interface | I2C | |
| Tamanho | 0,71 polegadas | |
Classificações Máximas Absolutas
| Parameter | Símbolo | Valor Min | Valor Máximo | Unidade |
|---|---|---|---|---|
| Supply Voltage for Logic | VDD | 0 | 4 | V |
| Supply Voltage for Display | VCC | 0 | 15 | V |
| Temperatura de operação | TOP | -40 | +80 | °C |
| Temperatura de armazenamento | TSTG | -40 | +85 | °C |
Características Eletrônicas
| Item | Símbolo | Condição | Valor Min | Valor Típico | Valor Máximo | Unidade |
|---|---|---|---|---|---|---|
| Supply Voltage for Logic | VDD | － | 1.65 | 3.0 | 3.3 | V |
| Supply Voltage for Display (Supplied Externally) |
VCC | － | 6.0 | 7.5 | 8.0 | V |
| Charge Pump Regulator Supply Voltage | VBAT | － | 3.0 | － | 4.2 | V |
| Charge Pump Output Voltage for Display (Generated by Internal DC/DC) | Charge Pump VCC |
－ | 7.0 | 7.5 | － | V |
| Input High Volt. | VIH | － | 0.8×VDD | － | VDD | V |
| Input Low Volt. | VIL | － | 0 | － | 0.2×VDD | V |
| Output High Volt. | VOH | － | 0.9×VDD | － | VDD | V |
| Output Low Volt. | VOL | － | 0 | － | 0.1×VDD | V |
| Display 50% Pixel on (VCC Supplied Externally) | ICC | VCC=7.5V | － | 10.0 | 15.0 | mA |
| Display 50% Pixel on (VCC Generated by Internal DC/DC) |
IBAT | － | － | 15.0 | 25.0 | mA |
FPC Options:
| Drawing | FPC Length | PIN | pitch | ZIF FPC or HOTBAR FPC | Interface | FPC No. | Create Date |
|---|---|---|---|---|---|---|---|
 |
16.0 | 14 | 0.7 | HOTBAR FPC | I2C | FPC2000701401XXXXX00 | 20160603 |
 |
11.2 | 14 | 0.7 | HOTBAR FPC | I2C | FPC2070001401XXXXX02 | 20180307 |
