COG 0,91 inç 128x32 Grafik OLED Ekran
Model No. WEO012832D
►2017 Taiwan Excellence Award
►Türü : Grafik (Çerçevesiz)
►Yapı : COG
►Boyut : 0.91 inç
►Suitable for wearable device
►128 x 32 dot matrisi
►IC:SSD1306
►3V güç sağlayıcı
►1/32 görev
►Ara yüz : SPI
►OLED Rengi: Beyaz / Sarı / Gök Mavisi
►Aşağıdaki tabloda bulunan diğer FPC seçenekleri
Açıklama
WEO012832D, çapraz boyutu 0,91 inç 128x32 COG OLED ekran modülüdür. Bu model 30,0 x 11,5 mm modül boyutuna ve 22,384 × 5,584 mm aktif alan boyutuna sahiptir. Bu model, ST7735S IC’de yerleşikti. Bu modül 4 kablolu SPI arayüzünü destekler.
Mantık için besleme voltajı (VDD) 2.8V ila 3.3V arasındadır; tipik değer 3V, 1/32 çalıştırma görevi, 2,000:1 kontrast oranı. Bu modül serisi -40 ℃ ile +80 ℃ arasındaki sıcaklıklarda çalışabilir; saklama sıcaklıkları -40 ℃ ile +85 ℃ arasında değişir.
Bu modül, ultra ince, hafif ve düşük güç tüketimli, küçük boyutlu bir COG OLED ekrandır. Akıllı ev uygulamaları, tıbbi cihazlar, taşınabilir cihazlar, giyilebilir cihazlar için çok uygundur.
FPC Seçenekleri
ÇIZIM
Data source ref: WEO012832DWPP3N00008
AYRINTILAR
Arayüz Pin Fonksiyonlari
No. | Sembol | Fonksiyon |
---|---|---|
1 | C2P | Positive Terminal of the Flying Inverting Capacitor Negative Terminal of the Flying Boost CapacitorThe charge-pump capacitors are required between the terminals. They must be floated when the converter is not used. |
2 | C2N | |
3 | C1P | |
4 | C1N | |
5 | VBAT | Power Supply for DC/DC Converter Circuit This is the power supply pin for the internal buffer of the DC/DC voltage converter. It must be connected to external source when the converter is used. It should be connected to VDD when the converter is not used. |
6 | VSS | Ground of Logic Circuit This is a ground pin. It acts as a reference for the logic pins. It must be connected to external ground. |
7 | VDD | Power Supply for Logic This is a voltage supply pin. It must be connected to external source. |
8 | CS# | Chip Select This pin is the chip select input. The chip is enabled for MCU communication only when CS# is pulled low. |
9 | RES# | Power Reset for Controller and Driver This pin is reset signal input. When the pin is low, initialization of the chip is executed. |
10 | D/C# | Data/Command Control This pin is Data/Command control pin.. When the pin is pulled high and serial interface mode is selected, the data at SDIN is treated as data. When it is pulled low, the data at SDIN will be transferred to the command register. |
11 | SCLK | When serial mode is selected, D1 will be the serial data input SDIN and D0 will be the serial clock input SCLK. |
12 | SDIN | |
13 | IREF | Current Reference for Brightness Adjustment This pin is segment current reference pin. A resistor should be connected between this pin and VSS. Set the current lower than 30uA. |
14 | VCOMH | Voltage Output High Level for COM Signal This pin is the input pin for the voltage output high level for COM signals. A capacitor should be connected between this pin and VSS. |
15 | VCC | Power Supply for OEL Panel This is the most positive voltage supply pin of the chip. A stabilization capacitor should be connected between this pin and VSS when the converter is used. It must be connected to external source when the converter is not used. |
Genel Özellikler
Kalem | Ölçü | Birim |
---|---|---|
Nokta Matrisi (Çözünürlük) | 128 × 32 | dot |
Modül ölçüleri | 30.0 × 11.5 × 1.26 | mm |
Aktif alan | 22.384 × 5.584 | mm |
Nokta boyutu | 0.152 × 0.152 | mm |
Nokta sıklığı | 0.175 × 0.175 | mm |
Display Mode | Pasif Matrisli | |
Display Color | Monokrom | |
Drive Duty | 1/32 Duty | |
IC | SSD1306 | |
Arayüz | 4-wire SPI | |
Boyut (Köşegen) | 0.91 inç |
Maksimum Değerler
Parameter | Sembol | Minumum Deger | Maksimum Deger | Birim |
---|---|---|---|---|
Supply Voltage for Logic | VDD | 0 | 4.0 | V |
Supply Voltage for Display | VCC | 0 | 16.0 | V |
Çalışma Sıcaklığı | TOP | -40 | +80 | °C |
Storage Temperature | TSTG | -40 | +85 | °C |
Elektronik Özellikleri
DC Elektronik Özellikleri
Kalem | Sembol | Durum | Minumum Deger | Tipik Deger | Maksimum Deger | Birim |
---|---|---|---|---|---|---|
Supply Voltage for Logic | VDD | - | 2.8 | 3.0 | 3.3 | V |
Supply Voltage for Display (Supplied Externally) | VCC | - | 7 | 7.25 | 8 | V |
Charge Pump Regulator Supply Voltage | VBAT | - | 3.0 | - | 4.2 | V |
Charge Pump Output Voltage for Display (Generated by Internal DC/DC) | Charge Pump VCC |
- | 7.0 | 7.5 | - | V |
Input High Volt. | VIH | - | 0.8×VDD | - | VDD | V |
Input Low Volt. | VIL | - | 0 | - | 0.2×VDD | V |
Output High Volt. | VOH | - | 0.9×VDD | - | VDD | V |
Output Low Volt. | VOL | - | 0 | - | 0.1×VDD | V |
Operating Current for VCC (VCC Supplied Externally) | ICC | VCC =7.25V | - | 7 | 11 | mA |
Display 50% Pixel on (VCC Generated by Internal DC/DC) | IBAT | - | - | 15 | 25 | mA |
FPC Seçenekleri:
Resim | FPC Length | PIN | pitch | ZIF FPC or HOTBAR FPC | Arayüz | FPC No. | Create Date |
---|---|---|---|---|---|---|---|
17.06 | 15 | 0.65 | HOTBAR FPC | SPI | FPC2065001501XXXXX00 | 20140827 | |
40.76 | 15 | 0.5 | ZIF FPC | SPI | FPC2050001511XXXXX02 | 20150421 | |
11.26 | 14 | 0.62 | HOTBAR FPC | I2C | FPC2062001401XXXXX02 | 20160106 |
Search keyword: 128x32 oled, oled 128x32, 0.91 oled, 0.91" oled, 0.91 inç oled, oled 0.91, oled 0.91"