우리는 귀하의 프라이버시를 소중히 여깁니다
"모든 쿠키 허용"을 클릭하면 사이트 탐색을 개선하고, 사이트 사용을 분석하며, 마케팅 및 성능 노력에 도움을 주기 위해 쿠키를 귀하의 장치에 저장하는 데 동의한 것으로 간주됩니다. 이 주제에 대한 추가 정보는 당사의 정책에서 확인할 수 있습니다. 개인정보 보호정책

| Pin No. | 기호 | Level | 설명 |
|---|---|---|---|
| 1 | P/S | I | This is the parallel data input/serial data input switch terminal. |
| 2 | C86 | I | This is the MPU interface switch terminal. |
| 3 | VR | I | Output voltage regulator terminal. Provides the voltage between VSS and V0 through a resistive voltage divider. |
| 4~8 | V0~V4 | Power supply | This is a multi-level power supply for the liquid crystal drive. |
| 9 | CAP2N | O | DC/DC voltage converter. Connect a capacitor between this terminal and the CAP2P terminal. |
| 10 | CAP2P | O | DC/DC voltage converter. Connect a capacitor between this terminal and the CAP2N terminal. |
| 11 | CAP1P | O | DC/DC voltage converter. Connect a capacitor between this terminal and the CAP1N terminal. |
| 12 | CAP1N | O | DC/DC voltage converter. Connect a capacitor between this terminal and the CAP1P terminal. |
| 13 | CAP3P | O | DC/DC voltage converter. Connect a capacitor between this terminal and the CAP1N terminal. |
| 14 | VOUT | O | DC/DC voltage converter. Connect a capacitor between this terminal and vss or VDD |
| 15 | VSS | Power supply | Ground |
| 16 | VDD | Power supply | Power supply |
| 17~24 | D7~D0 | I/O | This is an 8-bit bi-directional data bus that connects to an 8-bit or 16-bit standard MPU data bus. |
| 25 | /RD(E) | I | The data bus is in output status when this signal is “L” |
| 26 | /WR(R/W) | I | The data bus are latched at the rising edge of the WR signal |
| 27 | A0 | I | This is connect to the least significant bit of the Norman MPU address bus, and it determines whether the data bits are data or a command. |
| 28 | /RES | I | When RES is set to “L”, the setting are initialized. |
| 29 | /CS1 | I | This is the chip select signal. |
| 항목 | 치수 | 단위 |
|---|---|---|
| 점의 수 | 128 x 64 | - |
| 모듈 치수 | 60.1 x 44.5 x 5.01(MAX) | mm |
| 보기 영역 | 54.6 x 32.0 | mm |
| 활성 영역 | 49.89 x 27.49 | mm |
| 도트 크기 | 0.36 x 0.4 | mm |
| 도트 피치 | 0.39 x 0.43 | mm |
| 듀티 | 1/65 , 1/9 Bias | |
| 역광 타입 | LED | |
| IC | ST7565P | |
| 인터페이스 | 6800/8080/4-Line SPI | |
| 항목 | 기호 | 최소값 | 대표값 | 최대값 | 단위 |
|---|---|---|---|---|---|
| 작동 온도 | TOP | -20 | - | +70 | ℃ |
| 보관 온도 | TST | -30 | - | +80 | ℃ |
| Power Supply Voltage | VDD | -0.3 | - | 3.6 | V |
| Power supply voltage (VDD standard) | V0,VOUT | -0.3 | - | 14.5 | V |
| Power supply voltage (VDD standard) | V1,V2,V3,V4 | -0.3 | - | V0+0.3 | V |
| 항목 | 기호 | 조건 | 최소값 | 대표값 | 최대값 | 단위 |
|---|---|---|---|---|---|---|
| Supply Voltage For Logic | VDD-VSS | - | 2.7 | 3.0 | 3.3 | V |
| Supply Voltage For LCM | V0-VSS | Ta=-20℃ Ta=25℃ Ta=70℃ |
- 9.2 - |
- 9.5 - |
- 9.8 - |
V V V |
| Input High Volt. | VIH | - | 0.8 VDD | - | VDD | V |
| Input Low Volt. | VIL | - | VSS | - | 0.2VDD | V |
| Output High Volt. | VOH | IOUT=-0.5mA | 0.8VDD | - | VDD | V |
| Output Low Volt. | VOL | IOUT=0.5mA | VSS | - | 0.2VDD | V |
| Supply Current(No include LED Backlight) | IDD | VDD=3.0V | - | 0.1 | 2.0 | mA |
"모든 쿠키 허용"을 클릭하면 사이트 탐색을 개선하고, 사이트 사용을 분석하며, 마케팅 및 성능 노력에 도움을 주기 위해 쿠키를 귀하의 장치에 저장하는 데 동의한 것으로 간주됩니다. 이 주제에 대한 추가 정보는 당사의 정책에서 확인할 수 있습니다. 개인정보 보호정책