首頁 產品介紹 OLED顯示器 繪圖型 OLED 顯示器 WEO012832G

1.71 吋 繪圖型 OLED 模組

型號 WEO012832G

►類型: 繪圖型
►結構: COG
►尺寸: 1.71吋
►128 x 32 點陣
►內建控制器SSD1307
►3V電源電壓
►1/32 duty
►介面: SPI, I2C
►發光顏色: 白色 / 黃色
►其它FPC選項請參閱最下方表格說明

產品敘述

WEO012832G是一款1.71吋的PM OLED顯示器模組,解析度128x32 pixels。此款模組內建SSD1307 IC,模組支援 I2C與4-線SPI介面,3V電源供應,1/32 duty驅動。

1.71” 的WEO012832G是COG結構的OLED顯示器,無需背光非常輕薄,適用於智能家電產品、攜帶型裝置、智慧醫療產品、量測儀器等產品。此模組的工作溫度是-40℃至+80℃,儲存溫度-40℃至+85℃。

 

規格圖


Data source ref: WEO012832GWAP3N00000

產品規格

Pin功能定義

No. 符號 功能說明
1 N.C. (GND) Reserved Pin (Supporting Pin)
The supporting pins can reduce the influences from stresses on the function pins. These pins must be connected to external ground.
2 VCC Power Supply for OEL Panel
This is the most positive voltage supply pin of the chip. A stabilization capacitor should be connected between this pin and VSS when the converter is used. It must be connected to external source when the converter is not used.
3 VLSS Ground of Analog Circuit
This is an analog ground pin. It should be connected to VSS externally.
4 VSS Ground of Logic Circuit
This is a ground pin. It acts as a reference for the logic pins. It must be connected to external ground.
5 VDD Power Supply for Logic
This is a voltage supply pin. It must be connected to external source.
6 CS# Chip Select
This pin is the chip select input. The chip is enabled for MCU communication only when CS# is pulled low.
7 RES# Power Reset for Controller and Driver
This pin is reset signal input. When the pin is low, initialization of the chip is executed.
8 D/C# Data/Command Control
When the pin is pulled high and serial interface mode is selected, the data at SDIN is treated as data. When it is pulled low, the data at SDIN will be transferred to the command register. In I2C mode, this pin acts as SA0 for slave address selection.
9~11 D0~D2 Host Data Input/Output Bus
When serial interface mode is selected, D0 will be the serial clock input: SCLK; D1 will be the serial data input: SDIN.
When I2C mode is selected, D2, D1 should be tied together and serve as SDAout, SDAin in application and D0 is the serial clock input, SCL.
12 IREF Current Reference for Brightness Adjustment
This pin is segment current reference pin. A resistor should be connected between this pin and VSS. Set the current lower than 12.5μA.
13 VCOMH Voltage Output High Level for COM Signal
This pin is the input pin for the voltage output high level for COM signals.  A capacitor should be connected between this pin and VSS.
14 VCC Power Supply for OEL Panel
This is the most positive voltage supply pin of the chip. A stabilization capacitor should be connected between this pin and VSS when the converter is used. It must be connected to external source when the converter is not used.
15,16 BS0 Communicating Protocol Select
These pins are MCU interface selection input. See the following table:
  BS0 BS1
I2C 0 1
3-wire SPI 1 0
4-wire SPI 0 0
BS1
17 VLSS Ground of Analog Circuit
This is an analog ground pin. It should be connected to VSS externally.
18 N.C. (GND) Reserved Pin (Supporting Pin)
The supporting pins can reduce the influences from stresses on the function pins. These pins must be connected to external ground.

規格說明

項目 尺寸 單位
解析度 128 × 32 Dots
模組尺寸 50.50 × 15.75 × 2.01 mm
檢視區域 42.22 × 10.54 mm
點大小 0.308 × 0.308 mm
點間距 0.33 × 0.33 mm
顯示模式 被動矩陣
發光顏色 單色
驅動方式 1/32 Duty
IC SSD1307
介面 SPI,I2C
尺寸 1.71 吋

電氣特性

項目 符號 條件 最小值 標準值 最大值 單位
邏輯電源電壓 VDD 2.8 3.0 3.3 V
顯示電源電壓 VCC 11.5 12.0 12.5 V
輸入高準位 VIH 0.8×VDD V
輸入低準位 VIL 0 0.2×VDD V
輸出高準位 VOH 0.9×VDD V
輸出低準位 VOL 0.1×VDD V
VCC (Full ON) 工作電流 ICC VCC=12.0V 14.5 19.0 mA

最大絕對額定值

參數 符號 最小值 最大值 單位
邏輯電源電壓 VDD -0.3 4.0 V
顯示電源電壓 VCC 0 16.0 V
工作溫度 TOP -40 +80 °C
儲存溫度 TSTG -40 +85 °C

FPC options

Drawing FPC Length PIN Pitch ZIF FPC or HOTBAR FPC Interface FPC No. Create Date
FPC2050001811XXXXX01_WEO012832GLAP3N00000 51.5 18 0.5 ZIF  SPI,I2C FPC2050001811XXXXX01 20170607
FPC2050001811XXXXX05_WEO012832GWAP3N00F00 121.08 18 0.5 ZIF  SPI,I2C FPC2050001811XXXXX05 20181030

Search keyword: 128x32 oled, oled 128x32, 1.71 oled, 1.71" oled, 1.71吋 oled, oled 1.71, oled 1.71"
go top
close