Pantalla TFT PCAP Touch Screen 5.7"
Modelo Nº WF57DTIACDNGD
►Tamaño : 5.7”
►Resolución : 320 x 240 puntos
►Dirección de la vista : 12H
►Interfaz : RGB
►Controlador integrado : --
►Placa de control : Opcional
►Brillo (cd/m²) : 700
►Agujero del bastidor : No
►Pantalla táctil : Con panel táctil capacitivo (PCAP)
►Detect Point : 5 Fingers
►O-Film : Opcional
DIBUJO

ESPECIFICACIONES
Función interfaz Pin
LCM PIN Definition
Pin No. | Símbolo | I/O | Función |
---|---|---|---|
1 | IF1 | I | Input data format control (Note1) |
2 | IF2 | I | Input data format control (Note1) |
3 | POL | O | Polarity Signal connect to VCOM driving circuit. |
4 | RESET | I | Hardware reset. |
5 | SPENA | I | Chip select |
6 | SPCL | I | Serial Clock |
7 | SPDA | I/O | Serial Data |
8 | B0 | I | Blue Data bit (LSB) |
9 | B1 | I | Blue Data bit |
10 | B2 | I | Blue Data bit |
11 | B3 | I | Blue Data bit |
12 | B4 | I | Blue Data bit |
13 | B5 | I | Blue Data bit |
14 | B6 | I | Blue Data bit |
15 | B7 | I | Blue Data bit(MSB) |
16 | G0 | I | Green Data bit(LSB) |
17 | G1 | I | Green Data bit |
18 | G2 | I | Green Data bit |
19 | G3 | I | Green Data bit |
20 | G4 | I | Green Data bit |
21 | G5 | I | Green Data bit |
22 | G6 | I | Green Data bit |
23 | G7 | I | Green Data bit(MSB) |
24 | R0 | I | Red Data bit(LSB) |
25 | R1 | I | Red Data bit |
26 | R2 | I | Red Data bit |
27 | R3 | I | Red Data bit |
28 | R4 | I | Red Data bit |
29 | R5 | I | Red Data bit |
30 | R6 | I | Red Data bit |
31 | R7 | I | Red Data bit(MSB) |
32 | Hsync | I | Horizontal synchronous signal |
33 | Vsync | I | Vertical synchronous signal |
34 | Data CLK | I | Dot data clock |
35 | AVDD | I | 4.5V~5.5V |
36 | AVDD | I | 4.5V~5.5V |
37 | Vcc | I | 3V~3.6V |
38 | Vcc | I | 3V~3.6V |
39 | NPC | O | NTSC/PAL mode Auto detection result H:NTSC/L:PAL |
40 | VGL | I | Gate off power |
41 | VGL | I | Gate off power |
42 | UD | I | Up/Down scan setting. H: Reverse scan / L: Normal scan |
43 | VGH | I | Gate on power |
44 | LRC | I | Shift direction of device internal shift register control. |
45 | GND | I | GROUND |
46 | VCOM | I | VCOM driving input |
47 | VCOM | I | VCOM driving input |
48 | ENB | I | Data enable input. Normally pull low. |
49 | GND | I | GROUND |
50 | GND | I | GROUND |
IF2,IF1 | Input data format |
---|---|
L,L(default) | Serial RGB |
L,H | Parallel RGB |
H,L | CCIR601 |
H,H | CCIR656 |
Backlight PIN Definition
Pin No. | Símbolo | I/O | Función |
---|---|---|---|
1 | VLED+ | I | Red, LED_ Anode |
2 | VLED- | I | Black, LED_ Cathode |
PCAP PIN Definition
Pin | Símbolo | Función |
---|---|---|
1 | VSS | Ground for analog circuit |
2 | VDDT | Power Supply : +3.3V |
3 | SCL | I2C clock input |
4 | NC | No connect |
5 | SDA | I2C data input and output |
6 | NC | No connect |
7 | /RST | External Reset, Low is active |
8 | NC | No connect |
9 | /INT | External interrupt to the host |
10 | VSS | Ground for analog circuit |
Especificaciones generales
Elemento | Dimensión | Unidad |
---|---|---|
Tamaño | 5.7 | pulgada |
Matriz de puntos | 320 × RGB × 240 (TFT) | puntos |
Dimensión del módulo | 126.00(W) × 101.55(H) × 8.235(D) (MAX) | mm |
zona activa | 115.2 × 86.40 | mm |
Distancia entre puntos | 0.12 × 0.36 | mm |
Tipo de LCD | TFT, Blanco, Transmisivo | |
Dirección de la vista | 12 o'clock | |
Dirección de inversión de escala de grises | 6 o'clock | |
Interfaz | 24-bit RGB | |
Relación de aspecto | 4:3 | |
Tipo de retroiluminación | LED, Blanco | |
PCAP FW Versión | FT5426 o equivalente | |
PCAP interfaz | I2C | |
PCAP IC | FN058A001_FT5426__V03_20180910_all.bin | |
Con o sin panel táctil | Con panel táctil capacitivo (PCAP) | |
Superficie | Deslumbramiento |
Valores nominales máximos absolutos
Elemento | Símbolo | Valor mín. | Valor típico | Valor máx. | Unidad |
---|---|---|---|---|---|
Temperatura de funcionamiento | TOP | -20 | - | +70 | ℃ |
Temperatura de almacenamiento | TST | -30 | - | +80 | ℃ |
Características electrónicas
Elemento | Símbolo | Condición | Valor mín. | Valor típico | Valor máx | Unidad |
---|---|---|---|---|---|---|
Supply Voltage For LCM | VCC | - | 3.0 | 3.3 | 3.6 | V |
Supply Voltage For CTP | VDDT | - | 2.8 | - | 3.3 | V |
Input High Volt. | VIH | - | 0.7 VCC | - | VCC | V |
Input Low Volt. | VIL | - | 0 | - | 0.3 VCC | V |
LCD Driving Supply Voltage | VGH x 1 | Ta=25℃ | - | 15 | - | V x 3 |
VGL x 2 | - | -10 | - | |||
VcomH | 2.5 | - | 5.5 | |||
VcomL | -2.0 | - | 0 | |||
Supply Current For LCM | IVCC | VCC=3.3V | - | 5 | 8 | mA |